smart card reader and writer software free download

You can run any of your applications from within the layers of the Windows Smart Card.

Windows Smart Card v.1.00 The Windows Smart Card from Zash Electronics is a smart utility that lets you handle your Windows applications by sorting them into classified categories as CARDS.

The virtual smart card is internally accessible as PC/SC reader and externally as USB CCID reader or through a contactless smart card.

Virtual Smart Card Architecture v.2012.04.11 The Virtual Smart Card Architecture provides software to emulate smart cards and a smart card reader.

Now you are ready to use the card in any POS/ATM.

Read the card again and see if all is ok for this simple run the software as admin, enter your card in the Hardware and from the software interface press the button Read Card allow it 15/30 sec and the data will show up if all is ok.

Press the button EXIT to exit the software, IMPORTANT DON’T PULL OUT THE CARD WHEN THE SOFTWARE IS OPEN EXIT THE SOFTWARE THEN YOU PULL-OUT THE CARD.

Now press Valid data a popup will show up with the data you write in the software interface please check if is correct if it is then press Burn-card Button and allow the software 30/1 Min in order for it to burn the data over the EMV Chip.

hex format since the POS/ATM is communicating in.

Enter The Pin code if you have it (If you are in USA and you want to use the card in POS then the PIN Is not Necessary but if you will like to use the Card in ATM then You need the Pin code).

Select The Card Expiration Data (The day is not Important Only the Month and Year).

Press the button Check ARQC Key and Check Master Key.

From the software Accept EPI MCI Credit Debit.

From the software Check the Box Generate a New ICVV For Each Transaction.

From the software Press Generate Master Key (This will Generate a Master Key).

From the software you can Select Type of Card like Visa, MasterCard etc.įrom the sotware Press the Button Generate ARQC Key (this will generate a unique ARQC Key).

On software select your card format and press “Check USD Port” you will be shown a pop once you are connected to com port.

Now connect your MCR200 to your laptop and on the software select your hardware and hit “Connect” after being connected and you will be provided with popup notification.

Run the emv.exe as admin on your computer after the installation is completed you will be asked for the license key which will provided with the instructions notepad provided along with the software.

Smart card reader and writer software free download